Actia — Psa Xs Evolution Drivers Upd

Modern Windows operating systems block unsigned drivers by default. Since many diagnostic drivers are modified for aftermarket use, you must temporarily disable this restriction.

If you have a clone (Chinese copy) of the ACTIA XS Evolution, it may require an older driver (e.g., FTDI version 2.8.30) due to counterfeit FTDI chip detection.

:

Interfaces with revision “B” are generally limited to DiagBox versions 5.x and below. They may not work properly with DiagBox 7.x or newer versions. Revision “C” interfaces support the full range of DiagBox versions, including 7.x and 9.x releases.

Having drivers installed is only half the battle. You must confirm the entire chain works. actia psa xs evolution drivers

Do not connect it to the car yet; just ensure the tool receives power from the USB port (an LED light should briefly flash or stay solid on some clones). Step 3: Update Driver via Device Manager Right-click the Start Menu and select .

If standard FTDI drivers fail, download (open-source USB driver installer). Run it, select your Actia device from the dropdown, and replace the driver with libusb-win32 or WinUSB . This bypasses the FTDI driver check entirely. Note: This may reduce speed slightly but is a proven fix for bricked clones. Modern Windows operating systems block unsigned drivers by

This usually indicates a firmware mismatch or a hardware clone issue. If you are using a cheap "Lexia 3 Clone" from online marketplaces, the serial number may have been blacklisted by newer Diagbox software updates. You will need to use PSA Interface Checker to flash an older, stable firmware version (like V4.3.2) to make the driver recognizable again. 3. Drivers Fail to Load in Virtual Machines