[ Odin Interface Layout Reference ] +-----------------------------------------------------+ | Options Tab | PIT Tab | | [X] Auto Reboot | +-----------------------+ | | [X] F. Reset Time | | Load .pit file here | | | [X] Re-Partition <-- | +-----------------------+ | +-----------------------------------------------------+ | Files Slots: [BL] [AP] [CP] [CSC] | +-----------------------------------------------------+ 4. Deploy a Patched Odin Version
: Go back to the Files section. Load the corresponding BL , AP , CP , and CSC files into their allocated slots. Note: Do not use the HOME_CSC file when performing a manual re-partition, as it attempts to bypass formatting and conflicts with the new layout.
to ensure your PC recognizes the device correctly in Download Mode. Try a Different Odin Version : If you're on an older device, try Odin v1.85 ; for newer devices, use Odin v3.14.4 Are you currently trying to your device or
The PIT file acts as a blueprint telling the phone where partitions like /system , /data , and /boot begin and end. If this blueprint gets corrupted, Odin rejects the write action. re-partition operation failed. odin
: Launch Odin and click on the dedicated PIT tab on the left side of the program window.
: If the internal physical storage chip degrades or suffers from bad blocks, it turns into a "read-only" chip that rejects layout changes entirely. Step-by-Step Solutions to Resolve the Error
: The physical flash memory chip inside the device has reached the end of its lifespan or suffered a hardware block failure, preventing it from accepting new partition layouts. Step-by-Step Solutions to Fix the Error Note: Do not use the HOME_CSC file when
By following these steps, you should be able to resolve the "Re-partition operation failed" error and restore your Samsung device to its normal state.
: Use an official OEM Samsung data cable. Avoid thin, third-party charging cables that lack reliable data synchronization pins.
"Re-partition operation failed" error in Odin typically occurs when the tool attempts to change the device's partition layout but lacks the necessary instructions (a PIT file) or encounters a hardware/connection mismatch. Primary Causes Missing PIT File : You have the "Re-partition" If this blueprint gets corrupted, Odin rejects the
Using a PIT file not designated for your exact model number, firmware version, or region.
: If re-partitioning is necessary, you must load the specific .pit file for your exact model and storage capacity into the PIT tab in Odin.
The error means: Odin sent the new partition layout, but the device rejected it.