V2000-c Rfid Access Control User Manual //free\\ < EASY • Collection >
💡 Presenting a card immediately after 11 or 13 is often easier than typing card number.
Always disconnect the power supply before wiring the device to prevent short circuits. Wire Color Codes and Functions
1,000 to 2,000 users (depending on the specific hardware revision) Card Reading Distance: 3–6 cm Compatible Card Type: EM (125 kHz) ID cards or key fobs Lock Output Load: Max 3A Alarm Output Load: Max 20A Operating Temperature: -10°C to 55°C (14°F to 131°F) Dimensions: Approximately 117mm × 75mm × 20mm 2. Terminal Wiring Definitions
Incorrect wiring is the #1 cause of V2000-c failure. Refer to the pinout diagram (usually on the rear of the device). V2000-c Rfid Access Control User Manual
Backlit keypad for visibility in low-light conditions.
I can provide specific configuration steps or layout tips based on your setup. Share public link
The V2000-c allows card+PIN or PIN-only access. 💡 Presenting a card immediately after 11 or
The V2000-C allows you to assign specific User IDs (from 1 to 1000) to keep track of individual users or delete lost cards easily.
Press * + Master Code + # (The indicator light changes color or flashes slowly).
Press 2 + X + # (where X is a number from 0 to 99 representing seconds). Terminal Wiring Definitions Incorrect wiring is the #1
You can customize how the lock behaves when valid access is granted. Access Modes (How Users Unlock the Door) : Press 3 âž” Press 0 âž” Press # . Card OR PIN (Default) : Press 3 âž” Press 1 âž” Press # . Card + PIN Combined : Press 3 âž” Press 2 âž” Press # . Adjusting Relay Strike Time
The V2000-C RFID Access Control is a standalone 125KHz EM card system supporting up to 1,000 users, offering adjustable door open times, and featuring a rugged plastic, non-waterproof design. While praised for its fast response time and versatility, users often report complex programming procedures. For official setup instructions, you can download the V2000-C User Manual directly from Obohands. programming NTIL V2000-c+ RFID Access Keypad - JustAnswer
An anti-tamper switch is located on the circuit board. When the back plate is securely attached, the switch is depressed and silent. If the device is forcibly removed from the wall, the switch will pop out and the unit will emit a continuous buzzing alarm.
