Cisco 851710 Install -

Verify the rack location provides adequate front-to-back or back-to-front clearance for the specific fan modules installed. Do not block the chassis ventilation holes. Electrical and Safety Precautions

Connect a grounding wire to the chassis ground point. Ethernet Connections (WAN/LAN):

Securely affix one rubber pad to each marked circular recess on the bottom panel. cisco 851710 install

Hold the 851710 by its ejector levers (both in the open position).

Switch# configure terminal Switch(config)# monitor capture test interface tengigabitethernet 5/1 both Switch(config)# monitor capture test match ipv4 protocol tcp any any Switch(config)# monitor capture test start Switch# show monitor capture test buffer brief Verify the rack location provides adequate front-to-back or

Do not touch the hardware until you have verified these five requirements:

(This example configures VLAN 1 with IP address 192.168.1.1/24 and enables it.) Below is a blog post template you can

Chapter: Using Setup Mode to Configure a Cisco Networking Device

Now you are ready to deploy your Cisco 851710 with confidence.

Below is a blog post template you can use, structured to cover the most common installation requirements for these hardware classes.